BeamBot XB18/20
BeamBot XB18/20
A rental-ready DMX pan/tilt platform built for 18k HMI (CMC, Sunray) and 20K Mole Richardson tungsten.
BeamBot XB18/20, Designed for 18k and 20k Film Lights…
Control
DMX input with straightforward channel mapping for pan/tilt and common programming parameters. The DMX Channels are adjusted by buttons on the control module. Important, set all channels to non dim, channel one can only operate if channel 2 is off and vice versa, channel 3 can only operate if channel 4 is off. Most Console operators program their board so each fixture has up/down/left/right arrows on screen so they can use the mouse to click on and off each channel
Ch 1 – Tilt Down
Ch 2 – Tilt Up
Ch 3 _ Pan Right
Ch – 4 Pan Left
Use mode button (figure 1) to select DMX and up/down buttons to select starting address. BeamBot uses 4 channels
Mounting
Multiple rigging options for I Beams, truss, or grid—built to keep the head secure and aligned.
Two Swivel burtons are all you need for a fast rig. The unit is 42 inches long and weighs around 20 pounds. Its Junior receiver is rated at 180 lbs.
Step 1 – Rig BeamBot to pipe or Ibeam roller units using two swivel burtons or equivalent. For orientation, “lamp left back” is marked on BeamBot. The control module is on lamp left. (figure 2)
Step 2 – insert the CMC/Sunray 18K fresnel or Mole 20K Fresnel lights junior spud into BeamBots Junior receiver, insert cotter pin, tighten receiver locking bolt located at bottom of receiver. Important note, the cotter pin holes and the BeamBot pan tab on receiver should be centered on the light for proper alignment.
Step 3 – Important, loosen both t handles to unlock yoke so lamp can tilt freely.
Step 4 – Attach lower actuator clamp to ear mounting plate as shown in figure 2/3
Power & cabling
120 volt AC 2.5 amps regular North American U-ground cord end. 5-Pin DMX in and out (m/f). Each Version 5 and higher come with built in USB A/C to power your wireless if required (you supply the Wireless)
Operational range
155 degrees of pan and 120 degrees of tilt you can easily smoothly focus your light in seconds for simple motivated light movement.
Specifications
BeamBot XB18/20K Automover Specs
BeamBot Automovers provide pan and tilt automation, (no flood or spot)
- Pan Rotation 155 deg
- Tilt Range +20 deg up to -80 deg down
- Power input 100 -135 Volts AC / 2.5 Amps
- Overall length (pipe) 42″ / 1066.8 mm
- Overall width 12 inch / 304 mm
- Junior Receiver bottom to top of BeamBot pipe 10 inches / 254 mm
- Weight approx. 40lbs / 18.3kg
- DMX 4 Channels
- DMX 5 pin input / output
- USB type A + C , 24 watt Fast Charge outlet
- Exact configuration may vary by rental package—confirm details when requesting a quote.